HT-10 hydraulic hot stamping machine output:10 tons 功能及特點： ．適合各類基材的燙金，包括：紙張、板紙、充皮紙、塑料片、PVC、布料等。 ．HT-10機運轉速度每分鐘可達到42轉。 ．油缸驅動結構設計，行程高，速度快。 ．配備有安全保護裝置，平臺式工作面，不受紙張限制，使用方便更安全。 ．送燙金箔方式根據工作需要，可采用一組或二組馬達式同步或跳步送箔。 送泊長度可隨意調節，燙金箔利用率高。 ．采用進口電器元件，機器性能卓越。 Functions and characteristics ．Apply for hot stamping on any kinds of basic materials, including paper, board, leatherette paper, plastic plate, PVC and cloth materials. ．Speed of HT-10 can reach 42 turns per minute. ．Elbow joint structure design, oil motor driving, high pressure and efficiency. ．Matched with safety protection device, plane working face, non-limited by paper, easy and safe to be used. ．Gold foil stamping can be used of double stepping motor to feed in foil in phase or leapfrog required by working. Or foil can be fed in cross or vertical direction. Length of fed-in foil can be adjusted at will, and availability of gold foil stamping is much high. ．Make using of imported electric component, hydraulic system is imported from Italy, and performance is excellent. 技術參數Technical Data 型號MODEL HT-10 中心距離（毫米）Throat Depth(mm) 330 輸出（公斤）Output(kg) 10000 送箔設計（馬達式）Foil Feed Device(motor)一組（one sets） 熱板面積（毫米）Size of Hot Plate(mm) 300*380 送箔方向Foil Feed Direction 橫向（side） 工作臺行程/毫米Stoke/mm 50 電熱（瓦）Heater Capacity(W) 2400 工作面積/毫米Table Size/mm 580*760 溫度調節Temperature Control 最高max.200℃ 最大紙張面積/毫米Max.Paper Size/mm 635*890 加壓時間/秒Dwell Time/ second 0-0.99 最小紙張面積/毫米Min.Paper Size/mm 297*210 馬力/千瓦M(jìn)otor Capacity/kw 4 最大工作高度/毫米Max.Daylight/mm 57 電源Power Source 3ph/380v/50HZ-6.8kw