產品名稱:FCC電容式電壓探棒F-CVP-1
品??? 牌:FCC
型??? 號:F-CVP-1
工作帶寬:9 kHz – 100 MHz
標稱增益探頭:- 20 dB
標稱增益平坦度:(150 kHz – 30 MHz): +/- 0.2 dB
(9 kHz – 100 MHz): +/- 1.5 dB
動態范圍:80 dB minimum
最小可測量的信號:(At 1kHz detection bandwidth) 10 dBuV
最大可測量的信號:約10 V
最大直徑:被測電線/電纜束:2公分為小于5pf的標稱負載電纜/捆測試
探頭電源:內置可充電鎳氫電池或鎳鎘,或一次性堿性電池(10 AA尺寸)
電池壽命:40 hours minimum
電池充電器:External, powered from 120 VAC
充電時間(最長):14 hours
連接器:Type N (female)
輸出連接器外形尺寸:7.7 inches High X 5.0 inches Wide X 8.0 inches Long (19.6 cm X 12.7 cm X 20.3 cm)
The Fischer Custom Communications, Inc. non-contact capacitive voltage probe (F-CVP-1) is used to measure the common mode voltage appearing between a multi-pair balanced cable bundle and the local ground reference for the cable bundle in accordance with CISPR 22 Section C.1.3. The F-CVP-1 makes this voltage measurement without requiring direct contact with the metallic conductors in the cable bundle, or requiring physically breaking the cable bundle to install the F-CVP-1.
The F-CVP-1 consists of 2 concentric metal electrodes. A capacitive voltage divider is formed by the capacitance between the cable bundle under test and the inner metal electrode of the F-CVP-1, and the capacitance between the inner and outer metal electrodes of the F-CVP-1. A Fischer Custom Communications, Inc. proprietary circuit buffers and amplifies the voltage from this capacitive divider, and provides a voltage out of the F-CVP-1 for direct input into a 50 O signal or spectrum analyzer.
The F-CVP-1 meets the critical requirement to minimize capacitive loading of cables under test. If the loading is greater than 5 pico farads the overall impedance of the cable under test can be significantly lowered and result in erroneous common mode voltage measurements.
Accessories Provided:
Rechargeable NiMH batteries
Battery Charger
Foam inserts to hold/position wire/cable under test inside CVP
Operating Manual
FCC公司的非接觸式電容電壓探針(F-CVP-1)被用于測量的共模電壓根據CISPR多對平衡電纜束和電纜束的局部接地參考之間出現22第C.1.3。這架F-CVP-1使得這個電壓測量,而無需使用金屬導體直接接觸的電纜束,或要求物理破壞電纜束安裝在F-CVP-1。